View and Download Motorola Symbol DS product reference manual online. Motorola Symbol DS Digital Imager Scanner. Symbol DS Barcode. User manual for the device Motorola SYMBOL DS Online user manual database. Please note- this programming guide is only intended for use with the RetailOps application. Please contact the manufacturer for standard.
|Published (Last):||9 November 2005|
|PDF File Size:||9.57 Mb|
|ePub File Size:||16.58 Mb|
|Price:||Free* [*Free Regsitration Required]|
No additional power supply is required.
Select Disable Image Cropping to present the full x pixels. It is always verified to guaranteethe integrity of the data. Enables the full illumination system default. Scanning 2 – 5 When the digital imager scanner senses movement, in its default Auto Aim trigger mode, it projects a red laser aiming pattern Figure which allows positioning the bar code or object within the field of view.
Enable or disable the events listed in Table and on the following pages by scanning theappropriate bar codes. Select increasing levels of security for decreasing levels of bar code quality.
Transmit Upc-e1 Check Digit Suppress Power-up Beeps The following statement is required to comply with US and international regulations: Disable this to transmit EAN-8 symbols as is. This parameter sets the time the digital imager scanner remains active after decoding. Connecting Power if Required Getting Started 1 – 4 Connecting Power if required If the host does not provide power to the digital imager scanner, connect an external power supply: Tell Us What You Think Advanced Data Formatting11 – 27ActionsSelect how to format the data for transmission.
Stop Bit Select Bits transmitted or received. Criteria can include code type e.
These new values mankal the standard default values in memory. TTL RS signal levels, which interface with most system architectures.
See page xv for contact information. Tell Us What You Think Usb Ignore Unknown Characters Symbology Parameter DefaultsTable lists the defaults for all symbologies parameters.
GreenA bar code was successfully decoded. It is broadcast by thecellular device when accessing the cellular system. There are two ways to change the default values: Tell us what’s mqnual.
Motorola SYMBOL DS6707 user manual
RS Interface 8 – 17Intercharacter DelayThis parameter specifies the intercharacter delay inserted between character transmissions. Select Do Not Buffer Code 39 to ds6077 all decoded Code 39 symbols immediately without being stored in the buffer.
Only Code 39 symbols which include a modulo 43 check digit are decoded, so only enablethis if the Code 39 symbols contain a Modulo 43 check digit.
Symbologies 10 – 79Redundancy LevelParameter 4EhThe digital imager scanner offers four levels of decode redundancy. The definition of the Graphic User Interface key depends on the attached system.
Check Parity 01h Do Not Check Parity 00h Software Handshaking Parameter 9Fh This parameter offers control of the data transmission process in addition to that offered by hardware handshaking.
Enable this tosend the keys in bold in place of the standard key mapping.
Motorola SYMBOL DS : Scanner User Manual
Connect the interface cable to the bottom of the digital imager scanner, as described in Installing the Interface Cable on page Disable Rule Set Jpeg Target File Size Before programming, follow the instructions in Chapter 1, Getting Started. Appendix A Standard Default Parameters Disable this to send nothing to the host if a symbol does notdecode.
If 2D is not present, the UPC bar code does not transmit. Selecting another RS host type bar code changes these settings. To change any option, scan the appropriate bar code s provided in the RS Host Parameters section beginning on page Scanning Introduction Chapter 2 Scanning Introduction This chapter provides beeper and LED definitions, techniques involved in scanning bar codes, general instructions and tips about scanning, and decode zone diagrams.
Symbol Code Identifiers Using Adf Bar Codes The data in the buffer is not affected.