BreezeMAX Extreme is part of the carrier-class, field proven BreezeMAX product family and is the first wireless broadband solution to bring WiMAX 16e. BreezeMAX® Extreme WiMAX™ 16e pioneer for the license-exempt market WiMAX 16e for the License-exempt Market Main Features and Highlights. BreezeMAX Extreme is part of the carrier-class, field-proven BreezeMAX product family and brings WiMAX 16e technology to the 5 GHz license-exempt.
|Published (Last):||17 May 2006|
|PDF File Size:||15.51 Mb|
|ePub File Size:||4.99 Mb|
|Price:||Free* [*Free Regsitration Required]|
Specifically when operating a dual-carrier BTS e.
BreezeMAX® Extreme (BreezeMAX Extreme ) |
Any service modification requires MS de-registration in order to take place. When upgrading to release 1. For details on the required changes, please refer to the application note: One may need to implement timers or other logic scripts in the AAA to close these sessions. When operating with DHCP option 66 and 67, the CPE might not receive an IP if option 67 is not used only 66 or if the option 67 xml file is not at the specified location.
The information is not submitted through the TR protocol. The documentation includes the following: Backhauling link must be under Eth. Please note, when downgrading from Release 1.
Upon successful completion the unit set automatically “run from shadow” and performs reset itself. Ping messages of bytes transmitted over R1 to the host behind CPE are sometimes unanswered. Recovery actions in case BTS was upgraded to 1. As part of these changes, several additional configuration options are available, such as: Due to FCC regulation requirements, starting with release 1. When performing backhauling over Extreme CPE i. Such cases might occur when using limited license CPEs and the total number of services defined for such a CPE is above the licensed value.
Although mentioned in extremme 20, when operating in release 1. It’s a community-based project which helps to repair anything. Network entry timeout prevent s full band scan in universal CC, thus workaround is needed to set only one BW to scan.
When deploying a multi sector site it is recommended using extrem single high profile GPS antenna kit along with GPS chaining cable CAT5e cable between the base-station on the same site.
The following is a general description: Each manual covers all relevant topics associated with the respective equipment, including: When BTS is operating with Release 1. CS to ensure management of the bridged BTS b. Cases in which the CPE is presented as linked, even though it is not. It corresponds to software versions: After switching between Operation Modes e.
breeezemax When connection with AAA is reestablished the entire cell will be authenticated again automatic de-registration of all CPE. In order to downgrade to release 1. The material contained herein is proprietary, privileged, and confidential.
NE failure when provisioning a capacity limit CPE model with services sum exceeding the capacity limit. Software is downloaded to the unit b.
Under dual sector SISO base-station, running a spectrum analyzer on one sector may lead as part of the scanning to BTS restart affecting the operation of the second sector. It is important to design carefully the frequency allocations and potential bands e.
The value may range between 1. This is mainly since IP address You may need to implement timers or other rbeezemax scripts in the AAA to close these sessions. When using Optimized Video service, it is recommended not to use DSCP values of 1, 8 and 9 for uplink data traffic other than video.
BreezeMAX ® Extreme 5000
Such DSCP values might interfere with the breezemaz. Cable to mains is NOT included and should be ordered separately. Please note that applying factory defaults will not change Country Code selection.
After link with BTS is established, the new version is Set as main automatically by the device Upgrade also the CPE to Release 1. Under GPS chaining, when there is a faulty chaining cable, the radio units in the chain may not initiate transmission.