This standard is issued under the fixed designation A /A M; the 1 This specification is under the jurisdiction of ASTM Committee A ASTM A/AM: Standard Specification for Steel, Sheet and Strip, Heavy- Thickness Coils, Hot-Rolled, Alloy, Carbon, Structural. Find the most up-to-date version of ASTM A at Engineering
|Published (Last):||19 December 2013|
|PDF File Size:||19.7 Mb|
|ePub File Size:||15.80 Mb|
|Price:||Free* [*Free Regsitration Required]|
The values stated in each system are not 1 This speci? Conformance to Annex A1 is mandatory when the “M” specification is used. No Tolerance Under 7 16 12 9 16? NOTE 3—This table was constructed by multiplying the values in the standard table by 0. Retests and Disposition of Non-Conforming Material NOTE 2—The term weight is used when inch-pound units are the standard.
It is included for that purpose only. Data sheets for overmetals, plastics, ceramics, and composites. Test Reports and Certi? Approved May 1, Property Data This page displays only the text of a material data sheet. Please contact us at webmaster matweb. However, under SI, the preferred term adtm mass.
Micrometers with pointed tips are not suitable asttm thickness measurements. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.
AK Steel ASTM A and A Hot Rolled Carbon Steel, Structural Steel (SS)
Notwithstanding aztm absence of a signature, the organization submitting the EDI transmission is responsible for the content of the report. Hot-rolled heavy thickness coils 12 in. A number in parentheses indicates the year of last reapproval.
Combining values from the two systems may result in non-conformance with the standard. Combining values from the two systems may result in nonconformance with this specification. Hot roll manufacturer de? These tolerances do not include crown, and, therefore, the tolerances given in Table A1.
Cast or heat analysis shall be made to z635 the conformance with the requirements.
We appreciate your input. Link to Active This link will always route to the current Active version of the standard. Crown Tolerances for Speci? The mechanical property requirements, number of specimens, awtm locations, and specimen orientation shall be in accordance with the applicable product specification.
Structural steel may be ordered when the coils are intended for conversion to plate steels.
ASTM A635 Grade 1018
These tolerances do not include crown, and, therefore, the tolerance given in Table A1. The values listed are not exact conversions of the values listed in the inch-pound tables, but instead are rounded or rationalized values. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
These elements are considered as incidental and are not normally determined or reported. However, the document shall clearly identify the organization submitting the document. Workmanship, Finish, and Appearance 9.
Pickled or blastcleaned material has cut edges; if mill-edge material is required, it must be speci? Or if you don’t have an account with us yet, then click here to register. Your comments will receive careful consideration at a meeting of the responsible technical committee, which sstm may attend. Committee A01 has identi? Such a deviation is obtained by placing a mm straightedge on the concave side and measuring the greatest distance between the strip edge and the straightedge.
The analysis shall be from a test sample preferably taken during the pouring of the heat or cast.