IMPORTANT. This User Manual should be used in conjunction with the DNB DeviceNet Scanner Module. Installation Instructions, publication DeviceNet. Logix DNB. RSLogix RediSTATION. DNB DeviceNet Scanner. Module Installation Instructions(DNB. DeviceNet.) Publication INB-EN-P – April Installation Instructions. ControlLogix DeviceNet. Scanner Module. Catalog Number DNB. Use this manual as.
|Published (Last):||2 December 2015|
|PDF File Size:||15.26 Mb|
|ePub File Size:||5.62 Mb|
|Price:||Free* [*Free Regsitration Required]|
We couldn’t understand how this had happened. Check slave device configuration. Anyway during the troubleshooting process the “Configuration button” maanual pushed a couple of times.
Preventing Mmanual Discharge The DeviceNet scanner module is sensitive to electrostatic discharge. Check system for failed slave devices or other possible sources of network interference.
Register a new account. No scan list is active in the module or no messages have been received by the scanner. Change of State The scanner module can send and receive data on a change of state basis with slave devices that also have this feature. When you apply chassis power, the alphanumeric display cycles through the following information: Thanks for your help Fuzzy. Identifies information that is critical for successful application and understanding of the product.
Industrial Automation Wiring and Grounding Guidelines, publication The display toggles through these elements until the error is corrected.
DNB configuration button – Allen Bradley –
Check network communication traffic. Posted 25 Oct Wear an approved wrist-strap 175-dnb device. Make sure that your module is connected to a valid network.
Make sure the module properly connects to the chassis backplane. Scanner is in RUN mode, outputs are under control, and inputs are being consumed. You control what information is exchanged through the scan list configuration and associated mapping functions of RSNetWorx for DeviceNet software.
Optional Firmware Build Number 4. Worn contacts may create electrical resistance that can affect module operation. Check DeviceNet connection on front of module. We then noticed that another node was 1756-dbb coming back onto the network. The device is operating correctly; however, no controller is controlling it. No direct network manuql for scanner detected. Just pulled up the manual, to make sure i was not smoking something. Electrostatic discharge can damage integrated circuits or semiconductors if you touch backplane connector pins.
The module creates all 3 structures whether or not DeviceNet nodes are configured or online. Select the network baud rate by pushing and holding the pushbutton. You need to be a member in order to leave a comment.
1756-DNB configuration button
If available, use a static-safe work station. Scanner is in IDLE mode, outputs are not under control, and inputs are being consumed. Like other slaves, the scanner module exchanges data with only one master when it is in slave mode. Verify module is completely inserted into chassis and backplane. For a Group 2 only device, this means that the device is not allocated to a master.
For a group 2 Only device, this means the device is allocated to a Master.
Select the network node address by pushing in and holding the pushbutton. The LED should be on for approximately 0.